47 interactive configurators for sizing drives, structures, power and thermal systems. Everything runs in your browser — nothing is uploaded, and no result is stored.
Resolution, counts per revolution and velocity quantisation for a feedback device.
Match an electronic speed controller to a motor: current, voltage and switching headroom.
Field-oriented control of a PMSM: current loops, SVPWM limits and operating envelope.
Force, duty cycle and thermal limits for a linear motor stage.
Torque, speed and thermal envelope for a brushless motor under load.
Torque-speed curves, microstepping and drive voltage for a stepper axis.
Winding factors, slot/pole combinations and back-EMF harmonics.
Deflection, bending stress and reactions for common beam loadings.
Dynamic and static load ratings against an L10 life target.
Pulley ratios, belt tension, pitch and centre distance.
Gear geometry, ratios, contact stress and module selection.
Rail and carriage selection from load, moment and travel life.
Compare candidate materials on stiffness, strength and density.
Rate, stress and free length for compression and extension springs.
Multi-stage ratio splits, efficiency and reflected inertia.
Natural frequencies, damping and forced response of a lumped system.
Fillet and butt weld sizing against applied load.
Ride, handling and actuator bandwidth for an active suspension.
Gear ratio and motor choice that minimise mass for a torque target.
Frame, stack and motor mounting patterns and clearances.
Thrust-to-weight, hover current and endurance for a multirotor.
Leg geometry, gait timing and actuator torque for a walking platform.
Reach, payload, joint torques and inertia for a serial manipulator.
Which drivetrain, power and compute parts interchange across a UGV platform.
Explore mass, range and payload trade-offs for a ground vehicle.
Cell count, capacity, C-rate and pack mass for a runtime target.
Trace width, current capacity, impedance and via sizing.
Topology, ripple and component stress for a DC supply.
Cascade noise figure and gain, plus antenna downtilt and coverage.
Array sizing, string voltage and expected yield.
Core, turns ratio and winding losses for a magnetic component.
Achievable loop bandwidth against plant and sensor limits.
Noise density, bias stability and integration drift for an inertial unit.
Gain selection and closed-loop response for a PID controller.
Range, resolution and error budget for a pressure measurement.
Bridge configuration, excitation and output for a strain measurement.
End-to-end latency budget across sensing, compute and actuation.
RTD, thermocouple and thermistor response and linearisation.
XFOIL-style lift, drag and pressure distribution for a section.
Duty, effectiveness and area for a heat exchanger.
Cylinder, pump and valve sizing for a hydraulic circuit.
Pressure drop, velocity and pipe sizing for a fluid run.
Head, flow and NPSH for a pump against a system curve.
Junction temperature, heatsink sizing and airflow.
Cycle analysis, thrust and specific fuel consumption.